ABB ACH550-01 User Manual page 216

ACH550-01 User's Manual
Code Description
1605 USER PAR SET CHG
Defines control for changing the User Parameter Set.
• See parameter 9902
• The drive must be stopped to change User Parameter Sets.
• During a change, the drive will not start.
Note: Always save the User Parameter Set after changing any
parameter settings or performing a motor identification.
• Whenever the power is cycled, or parameter 9902
changed, the drive loads the last settings saved. Any unsaved
changes to a user parameter set are lost.
Note: The value of this parameter (1605) is not included in the User
Parameter Sets, and it does not change if User Parameter Sets change.
Note: You can use a relay output to supervise the selection of User
Parameter Set 2.
• See parameter 1401.
0 = – Defines the control panel (operator keypad) as the only
NOT SEL
control for changing User Parameter Sets (using parameter 9902).
1 = 1 – Defines digital input
DI
Parameter Sets.
• The drive loads User Parameter Set 1 on the falling edge of the
digital input.
• The drive loads User Parameter Set 2 on the rising edge of the
digital input.
• The User Parameter Set changes only when the drive is stopped.
2...6 = 2...
DI DI
changing User Parameter Sets.
• See 1 above.
DI
-1 = 1( ) – Defines an inverted digital input
DI INV
changing User Parameter Sets.
• The drive loads User Parameter Set 1 on the rising edge of the
digital input.
• The drive loads User Parameter Set 2 on the falling edge of the
digital input.
• The User Parameter Set changes only when the drive is stopped.
-2...-6 = 2(
DI INV
as a control for changing User Parameter Sets.
• See 1(
DI INV
Parameter listing and descriptions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
APPLIC MACRO
1 as a control for changing User
DI
6 – Defines digital input
)... 6( ) – Defines an inverted digital input
DI INV
) above.
Range
-6...6
.
APPLIC MACRO
2... 6 as the control for
DI DI
1 as a control for
DI
is
2... 6
DI DI
211