Auto Standby Function; Activating Wireless Transmission Between Specific Units (Secure Link) - Sony HT-CT290 Operating Instructions Manual

• If the connected equipment is not
compatible with copyright-protection
technology (HDCP), the image and/or
the sound from the HDMI OUT jack of
this system may be distorted or may
not be output. In such a case, check
the specifications of the connected
equipment.

Auto standby function

The system enters standby mode
automatically when you do not operate
the system for about 20 minutes and
the system is not receiving an input
signal.
Hold down MOVIE/MUSIC for
5 seconds to turn on or off the auto
standby function.
On
The USB and TV indicators flash twice.
Off
The USB indicator flashes twice.
When the system enters standby mode,
all LED indicators except BLUETOOTH
indicator (blue) flash slowly.
Activating wireless
transmission between
specific units (Secure
Link)
You can specify the wireless connection
to link the Bar Speaker to the subwoofer
using the Secure Link function. This
function can help prevent interference if
you use multiple wireless products.
20
US
1
Press LINK on the rear of the
subwoofer.
The power indicator on the
subwoofer flashes in orange.
2
Hold down CLEAR AUDIO+ for
5 seconds.
The USB and TV indicators flash two
times, then the MOVIE and MUSIC
indicators flash alternately.
When the Bar Speaker is linked to
the subwoofer, the indicators stop
flashing and the power indicator on
the subwoofer lights up in orange.
If it failed, the indicators light up for
5 seconds. Try again the above
operation.
To deactivate this function, hold
down CLEAR AUDIO+ for
5 seconds.
The USB indicator flashes twice.