Power Up The Controller; Install The Software - Agilent Technologies M9405A User's And Service Manual

M9405A

Power up the Controller

CAUTION If you are using a remote controller and you have installed the interface cable, you must
power up the chassis before you power up the PC. As well, you must power down the PC
before you power down the chassis.
If you are using an embedded controller, complete the following steps:
1. Install the embedded controller module into the compatible chassis. The Agilent M9036A PXIe
Embedded Controller and Agilent M9018A PXIe Chassis are recommended. Please refer to the
embedded controller and chassis documentation for further details.
2. Connect peripherals (mouse, keyboard and monitor).
3. Turn On the chassis.

Install the Software

NOTE
Administrator privileges will be needed for software and hardware installation. This
includes first-time installation of a module in a different chassis slot.
The software installation includes the following:
NOTE Version 16.2 (or newer) of the Agilent IO Libraries Suite is required.
• The Agilent IO Libraries Suite CD (E2094-60003), includes the Agilent Connection Expert.
It is also available on the internet at:
• Instrument software, which includes the soft front panel (SFP), device driver (IVI-COM) and
documentation for the M9405A. This software CD is included with your shipment (M9499-10002).
Use the following procedure to install the software:
1. From the Agilent IO Libraries Suite CD (E2094-60003) browser, launch the installer.
2. Follow the installer prompts to install the IO Libraries Suite.
3. From the Product Software and Information CD (M9499-10002) browser, launch the installer.
4. Follow the installer prompts to install all software and documentation for the module.
5. After installation has completed, power down the host PC.
8
http://www.agilent.com/find/iosuite
Install the Software
User's and Service Guide M9499-90004