Table of Contents
Advertisement
M9405A
Verifying the Shipment
To verify the content shipped with your module, refer to the "Box Content List" included with the shipment.
Inspect the shipping container for damage. Report any damage to the shipping agent immediately, such
damage is not covered by the warranty (warranty information can be found at the beginning of this
manual). Keep the damaged shipping materials (if any) for inspection by the carrier and an
Agilent Technologies representative. Refer to
Carefully remove the contents from the shipping container and verify that your order is complete. Confirm
that the options you ordered are included with the shipment. Refer to the serial number label on the side
panel and the packing literature included with the shipment.
Electrostatic Discharge Protection
Electrostatic discharge (ESD) can damage or destroy electronic components. The module is shipped in
materials which prevent damage from static, and should only be removed from the packaging in an
anti-static area ensuring that the correct anti-static precautions are taken.
Two types of ESD protection are listed below. Purchase acceptable ESD accessories from your local
supplier.
• Conductive table-mat and wrist-strap combination
• Conductive floor-mat and heal-strap combination
Both types, when used together, provide a significant level of ESD protection. To ensure user safety,
static-safe accessories must provide at least 1 MΩ of isolation from ground.
WARNING
These techniques for a static-safe work station should not be used when working on
circuitry with a voltage potential greater than 500 volts.
4
"Contacting Agilent" on page
User's and Service Guide M9499-90004
Verifying the Shipment
17.
Advertisement
Table of Contents
