Advertisement
NOTE: The bag may need changed frequently when picking up material such as powder
or fine dust or when cleaning new carpets.
Cleaning the washable pre-motor filter
1.
Lay the cleaner on a flat surface, pull back the door release button and remove the
bag door. [12]
2.
Remove the old pre motor filter by pressing the finger tab to release. [15]
Gently tap the filter against the side of a bin to release excess dust. [16]
3.
4.
If deeper cleaning is required: Wash the filter thoroughly under hand warm water
until the water runs clean. [17]
5.
Remove excess water by shaking and leave to dry for 24 hours. DO NOT UsE HOT
WATER OR DETERGENTS. [18]
6.
Refit bag door as above.
IMPORTANT - For optimum performance, shake off excess dust from the filters regularly.
We recommend that the filter is washed every 3 months.
NOTE: Do not use the cleaner without filters assembled.
ACCESSORIES
To obtain the best performance and energy efficiency#1 it is recommended that the
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters gP, HF or CA.
A nozzle type gP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as
required by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard floor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard floors.
#1 NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
All accessories can be fitted to the end of the handle or the end of the telescopic tube.
*Certain Models Only
** Certain models only, nozzles may vary according to model
Parquet Nozzle* – For parquet floors and other delicate floors.
Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile
surfaces and other hard to clean areas. Particularly suitable for allergen removal.
IMPORTANT: Do not use the turbo and mini turbo nozzles on rugs with long fringes,
animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while
the brush is rotating.
USER CHECklIST
should you have a problem with your product, complete the simple user checklist before
calling the Hoover customer service.
•
Is there a working electricity supply to the product? Check with another electrical
product.
•
Is the bag full? Inspect and replace.
•
Is the hose blocked? Check by stretching to the full length
•
Is the product inlet blocked? Check by removing the bag and checking the bag
inlet.
•
Is the filter blocked? Check by removing and clean.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Consumables
Disposable Bag
H68 - 35601148
Premotor Filter
s101 - 35601149
Spare parts
Hard Floor Extra Nozzle
G216EE - 35601609
Hard Floor Smart Nozzle: G218SE - 35601618
Carpet Nozzle:
G215EE - 35601608
Parquet Nozzle
G87PC - 35600655
Miniturbo Nozzle
J49 - 35601152
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
3
gb
Advertisement
