Dhcp; Vrf Configuration; Loading Vrf Cam; Creating A Non-Default Vrf Instance - Dell S6100 Configuration Manual

Feature/Capability
OSPFv3
IS-IS
BGP
ACL
Multicast
NDP
RAD

DHCP

DHCP requests are not forwarded across VRF instances. The DHCP client and server must be on the same VRF instance.

VRF Configuration

The VRF configuration tasks are:
1 Enabling VRF in Configuration Mode
2 Creating a Non-Default VRF
3 Assign an Interface to a VRF
You can also:
• View VRF Instance Information
• Connect an OSPF Process to a VRF Instance
• Configure VRRP on a VRF

Loading VRF CAM

• Load CAM memory for the VRF feature.
CONFIGURATION
feature vrf
After you load VRF CAM, CLI parameters that allow you to configure non-default VRFs are made available on the system.

Creating a Non-Default VRF Instance

VRF is enabled by default on the switch and supports up to 64 VRF instances: 1 to 63 and the default VRF (0).
• Create a non-default VRF instance by specifying a name and VRF ID number, and enter VRF configuration mode.
CONFIGURATION
ip vrf vrf-name vrf-id
The VRF ID range is from 1 to 63. 0 is the default VRF ID.
Support Status for Default VRF
Yes
Yes
Yes
Yes
No
Yes
Yes
Support Status for Non-default VRF
Yes
Yes
Yes
No
No
Yes
Yes
Virtual Routing and Forwarding (VRF) 1009