Connect The System To The Pedestal; Connect The System To Power; Set The Clock - Bose WAVE SOUNDTOUCH SERIES IV Owner's Manual

I N I T I A L S E T U P
Connect the system to the
pedestal
The SoundTouch® pedestal provides the network connection for the
Wave® music system.
1. Carefully set your Wave® music system on top of the
SoundTouch® pedestal:
• Place the rear feet of the Wave® music system into the recesses
on top of the SoundTouch® pedestal.
• Make sure the Wave® music system sits flat and the side edges
of both parts are aligned.
2. Insert the SoundTouch® pedestal's cable into the Bose link
connector.

Connect the system to power

Before you set up the system on your network, connect the system
to power.
1. Insert the small end of the AC power cord into the
connector.
2. Plug the power cord into an AC (mains) power outlet.
6 - E N G L I S H

Set the clock

1. Press and hold either
HOLD TO SET appears on the display.
2. Release the selected Time button.
– CLOCK SET – appears on the display.
3. Press to adjust the time backward or press
adjust the time forward.
4. After five seconds, the system exits the clock setup mode.
Notes:
• The clock cannot be set in the SoundTouch® or Bluetooth® source.
• To change the clock display from 12-hour (AM/PM) time to
24-hour time, see "System Personalization" on page 21.
• If the system loses power due to a power outage or if unplugged,
all system settings are permanently retained and the clock time is
temporarily stored in backup memory (up to 48 hours).
or for one second.
to