a.
Battery (see
Battery on page
b.
USB port shield (see
c.
System board (see
Remove the WLAN module:
1.
Turn the system board upside down with the front toward you.
2.
Remove the Phillips PM2.0×2.3 screw (1) that secures the WLAN module to the system board. (The
WLAN module tilts up (2).)
3.
Remove the WLAN module (3) by pulling the module away from the slot at an angle.
Reverse this procedure to install the WLAN module.
42).
USB port shield on page
System board on page
51).
50).
Component replacement procedures
55