JVC FS-X3 Service Manual page 14

3.2 Top case assembly section
• Prior to performing the following procedures, remove the top
case assembly.
Note :
Be careful not to scratch the top case, volume control knob or
other parts.
3.2.1 Removing the CD mechanism assembly
(See Fig.17)
(1) From the inside of the top case assembly, remove the three
screws S attaching the CD mechanism assembly.
(2) Take out the CD mechanism assembly from the top case
assembly.
3.2.2 Removing the CD door mechanism assembly
(See Figs.17 and 18)
(1) Remove the cover in the direction of the arrow. (See
Fig.17.)
(2) From the inside of the top case assembly, disconnect the
wire from the connector
board. (See Fig.17.)
(3) Remove the three screws T attaching the gear bracket and
take out the gear bracket. (See Fig.17.)
(4) Remove the two screws U attaching the CD door mecha-
nism assembly and take out the CD door mechanism as-
sembly. (See Fig.17.)
Reference :
Before attaching the CD door mechanism assembly, put the
wire through the two slits j of the CD door mechanism assem-
bly and then attach the two screws U. (See Figs.17 and 18.)
1-14 (No.MB004)
CN461 on the CD door switch
Top case assembly
CD mechanism assembly
Fig.17
Fig.18
T
S
Gear bracket
CD door
mechanism
assembly
T
Cover
CD door
switch
board
CN461
U
CD door
mechanism assembly
Slits j