Page 2
K-50 Drain Cleaning Machine gress depends upon the sharpness of the tool and NOTE! By holding the cable against the edge of the inlet, in the FOR (FORWARD) position, the ro- nature of the obstruction. tation will rapidly “thread” the cable out of the line.
K-50 Drain Cleaning Machine progress depends on the type of tool being used and After attaching cable adapter to your K-50 Machine, test for proper braking action as follows: nature of the blockage. Advance cable slowly. 7. If cable gets hung up in the obstruction, release the 1.
Straight Auger, 5″ Long Machine. Other accessories suitable for use with other ″ O.D. 62995 T-202 Bulb Auger, 1 tools may become hazardous when used on the K-50. To ″, O.D. 63000 T-203 Bulb Auger, prevent serious injury, use only the recommended ac-...
4. If worn, replace the clutch jaw assembly. authorized RIDGID service technician. 5. Reinstall the jaws into the housing and replace the Tool should be taken to a RIDGID Independent Auth- rack and pinion assembly. orized Service Center or returned to the factory. All repairs made by Ridge service facilities are warranted against 6.