Electrolux ERF4162AOW User Manual page 10

10 www.electrolux.com
Problem
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Shopping‐
Mode, or after changing
the temperature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The ShoppingMode func‐
tion is switched on.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is in dem‐
onstration mode.
Solution
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "ShoppingMode
function".
The compressor starts after
a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.