H1157511-73,525RS,GBCN.fm Page 13 Wednesday, August 26, 2015 4:03 PM
•
Screw on the trimmer head/plastic blades (H) counter
clockwise.
H
H
•
To dismantle, follow the instructions in the reverse
order.
Fitting a blade guard, grass blade
and grass cutter
G
F
D
A
•
Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.
CAUTION! Use the recommended blade guard. See the
Technical data section.
•
Fit the drive disc (B) on the output shaft.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Place the blade (D), support cup (E) and support
flange (F) on the output shaft.
•
Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner
ASSEMBLY
E
B
C
in the opposite direction to the direction of rotation
(Caution! left-hand thread).
–
English
13