1.5
Setting up tools
Selecting the correct operating mode
Tools are set up in the Manual operation mode:
Press the operating mode key for the TNC to
switch to Manual operation operating mode
Manual operation
Further information on this topic
Operating modes of the TNC
Further Information:
Preparing and measuring tools
Clamp the required tools in their tool holders
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: store the tools in the tool
changer
Further Information:
page 73
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
"Modes of operation", page 81
"The pocket table TOOL_P .TCH",
Setting up tools
1
1.5
71