Regulatory Compliance; Industry Canada - Seagate Wireless Plus User Manual

Regulatory Compliance

FCC Class B Informa on
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
:following measures
.Reorient or relocate the receiving antenna
.Increase the separation between the equipment and receiver
.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
.Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
.including interference that may cause undesired operation
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
.could void the user's authority to operate this equipment
IMPORTANT NOTE: FCC Radia on Exposure
Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
.equipment should be installed and operated with minimum distance 20cm between the radiator & your body
.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
The availability of some specific channels and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destination. The firmware setting is not accessible
.by the end user
Note to US model owner: To comply with US FCC regulation, the country selection function has been
.completely removed from all US models. The above function is for non-US models only

Industry Canada

3 7/28/15 Seagate Wireless Plus