Graco XM 24W626 Operation Manual page 71

System Setup Screens
System Setup enables users to configure system set-
tings for fluid control and operator interaction. Refer to
the following table for details.
NOTE:
Some system settings must be enabled from the Enable
Setup screens before users can change or set configu-
rations. See Enable Setup Screens, page 73, for
instructions.
Icon Function
Set number of minutes before mixed mate-
rial will set in hose. Resets after material
volume set by user is passed through hose.
Indicates total hose volume. Always dis-
played in cc units.
Set length of hose after mix manifold. Used
to indicated total hose volume.
Set calendar date and format.
Set time.
Set USB language.
Set units of measurement desired for dis-
play, such as fluid and temperature.
Set sprayer number if using more than one
sprayer.
Set how often data will record to USB ratio
and spray logs.
Set number of hours of recorded data to
download to USB flash drive.
Set the A and B side metering pump sizes.
Volume ratio reference
Weight ratio reference
Ratio Pass Tolerance
3A2776H
Appendix A - User Interface Display
Potlife/Hose Length
This screen enables users to set the potlife timer, and
length of each mixed material hose specific to the sys-
tem. The total mixed material volume is then calculated
and displayed on the page. The potlife time displays in
the upper right corner.
When the fluid flow stops the displayed potlife time
counts down in one minute intervals. The timer automat-
ically resets when the calculated mixed fluid volume is
dispensed.
71