Service Menu - Hitachi CP-X880 Service Manual

SERVICE MENU

SERVICE
yellow(selected item)
FANSPEED
B-SPEED
DURABLE
VIDEO NR
LENS
MUTE COLOR
FILTER TIME
input picture
or
start_up screen
Setup of a Cooling Fan Speed
When using this projector in the place where altitude is high, we recommend you to set a cooling fan's speed
as "HIGH". It is because the cooling effi ciency of a projector falls and the temperature inside a projector rises
easily in such a place, since the density of air becomes low.
Setting Method of Cooling Fan Speed
1. Select the "FAN SPEED" on the OSD using button " " by the SERVICE MENU.
2. Select the "HIGH" on the OSD using the button " ". To reset this setup, select the "NORMAL" using the
button " ".
3. The OSD will be ended by no operation for 10 seconds or change of input signal. To end immediately, use
one of buttons except buttons " ", "
NOTE:
The "HIGH" mode makes the fan noisy than "NORMAL" mode.
The recall of factory setting sets the fan speed to "NORMAL" mode. You must set the fan speed after recall
of factory setting if you need "HIGH" mode.
CP-X880/CP-X885
To display the OSD for "SERVICE MENU" set up.
By the control panel
1. Display the menu by the
"MENU" button.
2. Select the "OPT." on the menu.
3. Continue press the button " "
fi rst, then press the button " "
together with "RESET", and
hold for 3 seconds.
same as the menu color
white(not selected item)
FANSPEED NORMAL
", " ", " ".
By the remote control transmitter
1. Display the menu by the
2. Select the "OPT." on the menu.
3. Continue pressing the button
HIGH
yellow(selected item)
29
"MENU" button.
"MAGNIFY OFF" for 3 seconds.