Preparations; Rear Connections - Philips FW-V520 User Manual

Preparations

AM loop
antenna
speaker
(right)

Rear Connections

The type plate is located at the rear of the
system.
A
Power
Before connecting the AC power cord to the
wall outlet, ensure that the following are done;
– If your system is equipped with a
Voltage Selector, set the VOLTAGE
SELECTOR to the local power line
voltage.
– All other connections have been made.
WARNING!
– For optimal performance, use only the
original power cable.
– Never make or change any connections
with the power switched on.
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
8
pg 001-032/V520/21-Eng
Television
L
AUDIO
R
VIDEO
IN
D
VIDEO OUT
(CVBS)
B
AUX/
CDR
IN
E
AM ANTENNA FM ANTENNA
SUBWOOFER
OUT
MAINS
C
+
R
–
–
L
+
SPEAKERS 6Ω
B
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
G Position the antenna as far as possible from a TV,
G For better FM stereo reception, connect an
8
FM wire
antenna
OUT
speaker
(left)
AC
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
AC power cord
Antennas Connection
Connect the supplied AM loop antenna and FM
antenna to the respective terminals. Adjust the
position of the antenna for optimal reception.
AM Antenna
VCR or other radiation source.
FM Antenna
outdoor FM antenna to the FM ANTENNA
terminal.
12/11/01, 5:05 PM
A
3139 115 21093