Features; Product Specifications - Black Max BMi1000 Operator's Manual

PRODUCT SPECIFICATIONS

ENGINE
Engine Type ..........Single Cylinder (OHV) Four Cycle, 54 cc
Replacement Spark Plug ........ Bosch A7RTC or equivalent
Engine Lubricant Volume...........................................8.5 oz.
Fuel Volume ............................................................. 0.6 Gal.
KNOW YOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
120 V AC RECEPTACLE
Your generator has a single phase, 60 Hz outlet that is a 120
Volt AC, 15 Amp receptacle. It can be used for operating
appropriate appliances, electrical lighting, tools, and motor
loads.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
AUTO IDLE SWITCH
The auto idle switch is used to control the speed of the
engine and conserve fuel. When the switch is in the ON (I)
position and no appliances are connected to the unit, the
engine will idle. If an appliance is added, the engine speed
will increase to power the item. If the appliance is removed,
the engine will return to idle.
CARRY HANDLE
The generator has a carry handle for easy transport.
CHOKE LEVER
The choke lever is used when starting the engine.
FUEL TANK
The fuel tank has a capacity of 0.6 gallon.
NOTE: The fuel flows from the fuel tank to the carburetor
only when the on/off switch/fuel valve is in the ON (I) position.

FEATURES

GENERATOR
Rated Voltage ............................................................. 120 V
Rated Amps ................................................................. 7.5 A
Rated Running Watts ................................................ 900 W
Starting Watts ......................................................... 1,000 W
Rated Frequency ........................................................ 60 Hz
GROUND TERMINAL
The ground terminal is used to assist in properly grounding
the generator to help protect against electrical shock.
Consult with a qualified local electrician for grounding
requirements in your area.
LED DISPLAY
LEDs provide feedback to indicate whether the generator is
in use, overloaded, or in need of lubricant.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
lubricant in the crankcase is insufficient.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
ON/OFF SWITCH/FUEL VALVE
The on/off switch/fuel valve is used in combination with the
starter grip and rope to start the generator. It is also used
to turn the generator off.
RESET BUTTON
The reset button is used to restore power if an overload
occurs. To restore power, depress the reset button.
STARTER GRIP AND ROPE
The starter grip and rope is used (along with the on/off
switch/fuel valve) to start the generator's engine.
VENTED FUEL CAP
The generator has a fuel cap with a vent that can be opened
and closed. During normal operation the vent should be in
the OPEN (I) position.
Page 10 — English