Power Connection; Aerial Connection - Sharp LC-32SH130E Service Manual

Operation Manual (Continued)
Viewing the Connections - Side Connectors
1. CI Slot is used for inserting a CI card. A CI card allows you to view all the channels that
you subscribe to. For more information, see "Conditional Access" section.
2. USB Inputs .
Note that programme recording feature is available via these USB inputs. You can
connect external hard disk drives to this input.
3. Video Input is used for connecting video signals of external devices.Connect the video
cable between the VIDEO IN socket on the TV and the VIDEO OUT jack on your device.
4. Audio Inputs are used for connecting audio signals of external devices. Connect the audio
cable between the AUDIO INPUTS on the TV and the AUDIO OUTPUT jacks on your device.
Note: If you connect a device to the TV via the VIDEO INPUT, you should also connect
your device with an audio cable to the AUDIO INPUTS of the TV to enable audio.
5. Component Video Input (YPbPr)
You can connect the component video and audio sockets with a device that has
component output. To do this, you must use the supplied component video connection
cable for enabling connection. First, plug single jack of the cable to the TV's YPbPr
socket (side). Afterwards, insert your component cable's (not supplied) connectors into
the plural part of the Component video connection cable. Colours of the connected
jacks should match.
6. Headphone
jack is used for connecting an external headphone to the system. Connect
to the HEADPHONE jack to listen to the TV from headphones (optional).
7. , switch is used for turning the TV on or off.

Power Connection

IMPORTANT: The TV set is designed to operate on 220-240V AC, 50Hz.
• After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.

Aerial Connection

• Connect the aerial ,cable TV plug to the AERIAL INPUT socket located at the rear of the TV.
A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_32883W_YPBPR_ROCKER_10072419_50185320.indd 10
is used for connecting component video.
English - 10 -
13
LC-32SH130E
LC-32SH130K
LC-32SH340E
03.06.2011 10:38:22