Removing The Hard Disk Drive - NEC Versa P700 Disassembly Manual

12. Disconnect the LCD cable at the back from the LCD panel.
Note: The LCD cable connector is hold in place with the aid of an additional transparent adhesive tape.
Be careful when removing the tape, not to cause any damage to either cable or connector.

Removing the Hard Disk Drive

Perform the following steps to remove the hard disk drive:
1. Turn the notebook up-side down.
2. Remove the screws shown in the picture below
3. Turn the notebook back in the normal position.
4. Remove the hard disk drive cover sliding out of its position it as shown next.
Fig. 25: Removing the LCD cable
Fig. 26: Removing the hard disk drive cover screws
NEC Versa P700 Disassembly Manual
(M2.5x12)
Page 15