Table of Contents
Advertisement
11.6.1 Antenna Configuration
- Select appropriate antenna control (Tone Burst or
DiSEqC) depending on your setup.
- Allocate the appropriate satellite(s) to the LNB(s).
Alternatively, launch auto-detection using the red colour key
for automatic identification of available satellites, then press
<EXIT> to go back to the Antenna Configuration screen.
Note: the system can detect the following satellites: ASTRA 19.2°
East, HOT BIRD 13° East, Eutelsat W, and Türksat 1C.
- If necessary, configure the more advanced settings as
described in the next paragraphs.
11.6.2 LNB Configuration
To change the LNB and symbol rate settings:
- Press the blue colour key from the Antenna Configuration
screen to access the LNB Configuration screen.
- Select the LNB type corresponding to the selected LNB
and the satellite it is pointing at.
- Select the desired satellite: default setting is ASTRA 19.2°
East.To select another satellite, press the blue colour key.
- Select the frequency range to be scanned: press the blue
colour key, and then select either FULL to scan the whole
frequency range, or CUSTOM to scan for a particular
frequency range. In the latter case, enter the range low
and high frequencies.
- From the LNB configuration screen, you may also access
the screen used to select symbol rates for the selected
LNB using the red colour key.
- Press <EXIT> once or twice to go back to the Antenna
Configuration screen.
11.6.3 Filter Configuration
To define the channels to be searched:
- Press the green colour key from the Antenna Configuration
screen to access the Filter Configuration screen.
- Select values for the following scanning filters:
• Channel Access: select from the available channel groups;
i.e. All, FTA (free-to-air), Premiere, or FTA+Premiere
SETTINGS 41
Advertisement
Table of Contents
