Lights - Fiat 500e 2017 User Manual

OPERATING YOUR VEHICLE

LIGHTS

Multifunction Lever
The multifunction lever, located on the left side of the steering wheel, controls the opera-
tion of the headlights, headlight beam selection, passing light and turn signals.
NOTE:
The headlights can only be turned on with the ignition in the ON/RUN position.
Headlights
Rotate the end of the multifunction lever
upward to the first detent for headlight
operation.
NOTE:
When the headlights are turned on, the
Daytime Running Lights will be deactivated.
High Beams
Turn Signal/Lights Lever
With the low beams activated, push the
multifunction lever towards the instrument
panel to turn on the high beams. Pull the multifunction lever toward the steering wheel
to turn off the high beams.
Flash-To-Pass
You can signal another vehicle with your headlights by partially pulling the multifunction
lever toward the steering wheel. This will cause the high beam headlights to turn on until
the lever is released.
Parking Lights
To turn on the parking lights, remove the key or turn the ignition to OFF/LOCK position
and turn on the headlights.
Daytime Running Lights
To activate the Daytime Running Lights (DRL), rotate the end of the multifunction lever
to the O symbol.
NOTE:
The low beams and side/taillights will not be on with DRL.
If allowed by law in the country in which the vehicle was purchased the DRL function
can be turned on or off using the display menus. Refer to "Uconnect Settings" in "Under-
standing Your Instrument Panel" in your Owner' s Manual at
www.fiatusa.com/en/owners/manuals for further information.
65