Common Functions - Onkyo HT-S3100 Instruction Manual

Common Functions
This chapter explains functions that can be used with any input source.
DIMMER
TONE,-,
+
Press
[RECEIVER]
first
-AEIIOTEIIIOOE-
,~'=¥.-;;:;o;;;T.+.t- DIMMER
o
i
You can connect a pair of stereo headphones (l14-inch
phone plug) to the AV receiver's PHONES jack for pri-
vate listening, as shown.
You can adjust the bass or treble for speaker set A's front
speakers, except when the Direct listening mode is
selected.
Press the AV receiver's [TONE]
button repeatedly to select either
Bass or Treble.
Use the TONE [-]1[+] buttons to
adjust.
• Bass
You can boost or cut low-frequency sounds output by the
front speakers from -10 dB to
+
1 0 dB in 2 dB steps.
• Treble
You can boost or cut high-frequency sounds output by
the front speakers from
-10
dB to
+
10
dB in 2 dB steps.
Note:
• To bypass the bass and treble tone circuits, select the
Direct listening mode.
Notes:
• Always tum down the volume before connecting your
headphones.
• Speaker sets A and B are turned off while the head-
phones plug is 'inserted in the PHONES jack.
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it's already set to Mono,
Stereo, or Direct.
• When the multichannel DVD input is selected, only
the front left and front right channels can be heard in
the headphones.
With this function, you can adjust the brightness of the
display.
Press the [DIMMER] button
repeatedly to select: dim, dim-
mer, or normal brightness.
Alternatively, you can use the [DIM-
MER] button on the AV receiver (not
European models).
45