Programming For Machining Contours (Example 2) - Siemens SINUMERIK User Manual

13.3

Programming for machining contours (Example 2)

Workpiece drawing (unit: mm)
Blank data
Blank material: aluminum bar
Blank diameter: 45 mm
Blank length: 150 mm (machining limit along the Z axis: Z-95; three-jaw chuck clamping length: 40 mm)
Required tool
Tool type
35 ° finishing tool
Note
When programming in ISO mode, you need to set the H number of T2 to 2 in the tool list;
•
Cut the workpiece manually after machining is over.
•
Operating sequence for programming in Siemens mode
Programming and Operating Manual (Turning)
01/2017
Tool number
DIN ISO
T2D1 T0202
1. Select the program management operating area.
2. Press this softkey to enter the system directory for storing part programs.
3. Press this softkey and enter the name of the new program.
Roughing
Speed Feedrate
S1000 F0.2
Finishing
Speed Feedrate
S2000 F0.1
221