Presser Bar Height - Brother 888X62 Series Service Manual

Adjustment
[Standard]
When the presser foot is raised, the clearance between the bottom surface of the presser
foot and the surface of the needle plate should be 5.5 to 6.75 mm.
[Adjustment]
1. Turn off the power, and then remove the foot controller.
2. Remove the face plate assy.
3. Attach the presser foot "J".
4. Raise the presser foot lifter to raise the presser foot "J".
5. Loosen the screw of the presser bar clamp.
6. Move the presser bar (presser foot) up and down, and adjust the clearance between the bottom surface of the
presser foot and the surface of the needle plate.
*Key point
• When measuring the height of the presser foot "J", perform in the state that lower the feed dog than the
surface of the needle plate.
7. Tighten the screw of the presser bar clamp to secure the presser bar.
Presser bar
Presser bar clamp
5.5 - 6.75 mm
Needle
plate
surface

Presser bar height

Screw
Presser foot "J"
3 - 14
Presser foot lifter
Screw, M3X8