Practical information
Towing your vehicle
On the front bumper, driver's side, remove
the protective access cover located
alongside the front fog lamp, using the flat
end of the towing eye.
When removing the protective access
cover, take care to avoid damaging the
paintwork with the towing eye.
184
Screw the towing eye in fully.
Install the towing bar.
Switch on the hazard warning lamps on the
towed vehicle.
Place the gear lever in neutral.
Failure to observe this special condition
could result in damage to certain
braking components and the absence
of braking assistance the next time the
engine is started.
Towing another vehicle
On the rear bumper, unclip the cover by
pressing at the bottom.
Screw the towing eye in fully.
Install the towing bar.
Switch on the hazard warning lamps on
the towed vehicle.