Introduction - Yamaha MCP1 Installation Manual

Introduction

Thank you for purchasing the Yamaha MCP1 wall-mount controller. This product is a
wall-mount controller for controlling the MTX/MRX system. This installation manual
explains how to mount the unit when the installing technician or the designer installs or
sets-up the system. In order to take full advantage of this product's many functions, be
sure to read this installation manual before installation.
After reading this manual, keep it for future reference.
The MCP1 lets you set up a home page and six pages, and assign up to 36 parameters.
What you'll need to provide
When attaching the MCP1 to a wall, you'll need to provide several items.
• PoE injector or PoE network switch that supports IEEE802.3af
This is used between the MTX/MRX system and the MCP1 in order to supply power to the
MCP1.
PoE injector units and PoE network switches are collectively referred to as "PSE (Power
Sourcing Equipment)."
• Ethernet cables (CAT5e or better)
These are used between the MTX/MRX and the PSE, and between the PSE and the MCP1.
• (If embedding the unit in the wall)
2-gang box (without separator; 20 mm or greater depth)
You'll also need screws for attaching the gang box to the wall.
• (If using a surface mount box)
Screws for attaching the surface mount box to the wall × 4
Provide M4.0 flat head screws of a length appropriate for the thickness of the wall.
• Phillips screwdriver / electric screwdriver
This is used for installation.
6 MCP1 Installation Manual