Talk-Aroundl; 2-Tone Signalling; Select And Encodeing 2-Tone Signalling - Kenwood TK-760G Instruction Manual

TALK-AROUND
Occasionally, a power failure or other cause at the repeater may result in an
interruption of service. Your dealer may have provided the Talk-around function
for use in such cases. This function allows communication directly with other
tranceivers without using a repeater. However, even Talk-around may not allow
you to contact a station if the distance is too far or there are geographic
obstacles in the way.
To enable Talk-around function, press a key, programmed as Talk-around.
"TA" or "T." (depending on the configuration) will be displayed at the left side of
LCD display.
Note: When you are in Talk-around mode, all the signalling data, such as QT,
DQT, 2-tones are still enabled.

2-TONE SIGNALLING

2-tone signalling is either enabled or disabled by your dealer. 2-tone opens the
squelch only when the transceiver receives the preset two sequential tones that
have different frequencies.
When the correct tones are received that were programmed by your dealer, the
squelch opens, and the caller's voice is monitored.
Select and encoding 2-tone signalling
If "2-tone encode select" is programmed by your dealer, you can select 1
of 10preset 2-tone codes. Then you can sent the desired 2-tone to
another party.
1 Press a key, programmed as 2-tone encode select .
2 Select the desired a tone set, using Channel Up and Down key.
3 Press 2-tone encode select key again to set.
4 Press PTT to send the tone to another party.
11