Zte V9 User Manual page 10

V9 User Manual
FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions
accepted by the FCC with the tablet computer transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the tablet computer while operating can be
well below the maximum value. This is because the tablet computer is designed to
operate at multiple power levels so as to use only the poser required to reach the network.
In general, the closer you are to a wireless base station antenna, the lower the power
output.
The highest SAR value for the model tablet computer as reported to the FCC is 1.37W/kg
(Body-worn measurements differ among tablet computer models, depending upon
available enhancements and FCC requirements.)
While there may be differences between the SAR levels of various tablet computers and at
various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this model tablet computer with all
reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
SAR information on this model tablet computer is on file with the FCC and can be found
under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on
FCC ID: Q78-V9
For body worn operation, this tablet computer has been tested and meets the FCC RF
exposure guidelines for use with an accessory that contains no metal and the positions the
handset a minimum of 0.5 cm from the body. Use of other enhancements may not ensure
compliance with FCC RF exposure guidelines. If you do no t use a body-worn accessory
and are not holding the tablet computer at the ear, position the handset a minimum of 0.5
cm from your body when the tablet computer is switched on.
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Caution: Changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
2 Confidential and Proprietary Information of ZTE CORPORATION