Table of Contents
Advertisement
Before using the cordless phone
Before using the cordless phone
You must perform the following operations before attempting to use the WT9001 cordless
phone.
Charge (or recharge) the battery pack
The WT9001 cordless phone is supplied with a rechargeable battery pack and charger unit.
To charge the battery pack:
•
Remove the back cover of the cordless phone.
•
Insert the supplied battery pack in its housing as indicated.
•
Replace the back cover and snap firmly into place.
•
Place the cordless phone on the charger unit, with the keypad facing you.
•
Plug the charger unit in a 220/230V-50Hz wall socket.
•
The battery pack should remain at least twelve hours on the charger unit. When fully
charged, the message "100%" is displayed.
Register the cordless phone
To register the cordless phone, see the Installation manual.
Check the quality of the radio link
The WT9001 cordless phone automatically measures the quality of the radio link. To make
sure that you are within range of a base station and that your cordless phone is successfully
registered, you may view the quality of the radio link as follows:
•
Press the Menu button.
•
Press the INT button.
Note: The quality varies from 00 (very poor) to 99 (excellent).
Feature availability depends upon system administration. Check with your system manager.
No system
SYSTEMA KE1 KE2
RSSI:98 88 37
100%
7
Advertisement
Table of Contents
