Test Mode - Sony RM-NX7000 Service Manual

RM-NX7000
• How to enter the service mode
(The internal rechargeable battery must be fully charged.)
1. Turn the DC4.5V power ON for the main unit.
2. Press the main PC board S726 RESET switch.
3. Wait for 20 seconds after "NAVITUS" appears on the LCD,
until the backlight turns ON
4. Within one minute after the light goes out, hold MENU
depressed, then press RECALL and OK .
If input with these keys is accepted successfully, a beep sounds.
5. On the alignment screen, tap the cross "+" marks 3 times (at the
upper left, lower light and center).
* "Tap" refers to pressing the screen lightly with a stylus.
6. When tapping at the center is completed, the service mode menu
will be displayed.
• Initial display and contents of the service mode menu
Initial display
Service Mode Menu
AUTO
LCD
SEND
LEARN
ERP
KEY
MS
USB
EXIT
Use the cursor keys [ u ] and [ U ] to select an item and press OK
to enter on the menu.
AUTO...............Rotates through the enter menu.
LCD......White 80%(rotates in the order of 10 - 130 - 250
backlight)/White 80%/ White 50%/White 20%/Bar
(vertical) /Bar (horizontal)/Bar(horizontal narrow)
SEND....Sending check
LEARN..Learning function check
ERP........Touch engine click check
KEY.......Control key operation check
MS.........Write/Read check for memory stick
USB.......USB connection check
EXIT.................Exits the service mode.
8
SECTION 3

TEST MODE

1.0.1