Names Of Each Part - Hitachi C11XMB Service Manual

3. Names of each part

●
Part names
Zoom knob
Focus ring
Vent
Lens
Lamp cover
(Lamp unit is inside.)
Control buttons
(See the following page.)
Ports (See below.)
AC inlet
Power switch
COMPONENT
VIDEO ports
Y
C /P
B B
C /P
R R
AUDIO 2 L/R port
VIDEO port
S-VIDEO port
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
CP-X444(C11XMB)/CP-X440(C11XM25)
Front-Right side
B
Rear-Left side
Restart switch (*)
RGB IN1
RGB OUT
COMPONENT VIDEO
C /P Y
R R C /P
B B
R-AUDIO 2-L VIDEO S-VIDEO
Ports
3
Remote sensor
Elevator button
Elevator foot
Filter cover
(Air fi lter and intake vent
are inside.)
Speaker
Vent
RGB IN1 port
RGB IN2
AUDIO 1-IN AUDIO-OUT
RGB IN2 port
AUDIO-OUT port
CONTROL
AUDIO 1-IN port
CONTROL port
RGB OUT port
Elevator button
Elevator foot