Stihl MS 360 C Instruction Manual page 41

english / USA
:
Observe safety precautions.
:
Always check operation of chain
lubrication before starting work.
At very low outside temperatures:
: Allow engine to warm up at part
throttle.
:
Change over to winter operation
if necessary – see "Winter
Operation".
To shut down the engine:
: Move Master Control lever to $.
If fuel tank has been run until dry
and then refueled:
:
Press in button to open the
decompression valve.
: Pull starter rope several times until
fuel system is primed.
: Now start the engine.
40
3
2
1
If the engine doesn't start:
If you did not move the Master Control
lever to "Warm Start" n quickly enough
after the engine began to fire, the
combustion chamber has flooded.
:
Set Master Control lever (1) to l.
: Turn the twist lock (2) above the rear
handle 90° counterclockwise.
: Lift off the carburetor box cover (3)
vertically.
:
Clean away loose dirt from around
the filter.
:
Pull off the spark plug boot.
:
Take out the screw and remove the
shroud.
:
Unscrew and dry off the spark plug.
:
Set the Master Control lever to d
: Crank the engine several times with
the starter to clear the combustion
chamber.
:
Refit the spark plug. Connect the
spark plug boot (press it down
firmly).
: Set Master Control lever to n –
even if engine is cold.
:
Press in button to open the
decompression valve.
:
Now start the engine.
Fuel tank run dry and then
refueled:
:
Press in button to open the
decompression valve.
:
Pull the starter several times to
prime the fuel system.
MS 360 C