Apm Configuration; Network Stack Configuration; Hdd/Ssd Smart Information; Usb Configuration - Asus ROG STRIX B350-F GAMING Manual

Change Settings
This item appears only when you set the Serial Port to [On] and allows you to select
the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4] [IO=2F8h;
IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
3.6.5

APM Configuration

ErP Ready
Allows BIOS to switch off some power at S5 to get the system ready for ErP requirement.
When set to [Enabled], all other PME options will be switched off.
Configuration options: [Enable(S4+S5)] [Enable(S5)] [Disabled]
Restore AC Power Loss
[Power On]
[Power Off]
[Last State]
Power On By PCI-E
This item allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCIe LAN cards. Configuration options: [Disabled] [Enabled]
Power On By Ring
[Disabled]
[Enabled]
Power On By RTC
This item allows you to enable or disable the RTC (Real-Time Clock) to generate a wake
event and configure the RTC alarm date. When enabled, you can set the days, hours,
minutes, or seconds to schedule an RTC alarm date. Configuration options: [Disabled]
[Enabled]
3.6.6

Network Stack Configuration

The items in this menu allow you to configure Ipv4 / Ipv6 PXE support.
3.6.7

HDD/SSD SMART Information

This menu displays the SMART information of the connected devices.
3.6.8

USB Configuration

The items in this menu allow you to change the USB-related features.
The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.
3-16
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
The system goes into either off or on state, whatever the system state was
before the AC power loss.
Disables Ring to generate a wake event.
Enables Ring to generate a wake event.
Chapter 3: BIOS Setup