Certificate Management; Link Information; Link Status - CNET CWP-906E User Manual

Wireless Protection: Users can choose from Auto, on, and off.

adapters.)
Auto: STA will dynamically change as AP announcement.
On: The frames are always sent with protection.
Off: The frames are always sent without protection.
TX Rate: Manually select the transfer rate. The default setting is auto.

not allow the user to select the TX Rate.)
Enable TX Burst: Ralink's proprietary frame burst mode.

Enable TCP Window Size: Optimize the TCP window size to allow for greater throughput.

Fast Roaming at-: enables fast roaming, which is set by the transmit power.

Select Your Country Region Code: There are eight countries to choose from in the country channel

list. (11A ListBox only shows for 5G adapters.)
Show Authentication Status Dialog: When you connect to an AP with authentication, choose

whether show the "Authentication Status Dialog" or not. The Authentication Status Dialog displays
the processes during 802.1x authentication.
Apply the above changes.


5.4.2 Certificate Management

The Certificate Management configuration page as shown in Figure 2-4-2.
5.5

Link Information

5.5.1 Link Status

The link status page displays detailed information about the current connection as shown in Figure
2-5-1.
Figure 2-4-2 Certificate Management function
(This is not supported by 802.11n
(802.11n wireless cards do
CNet Technology Corporation.
www.CNetusa.com