Ford FOCUS Owner's Manual page 122

SelectShift does not automatically upshift,
even if the engine is approaching the RPM
limit. It must be shifted manually by
pressing the + button.
If equipped with the toggle on the
gearshift lever, press the + toggle
switch on the side of the gearshift lever
to activate SelectShift.
• Press the (+) button to upshift.
• Press the (-) button to downshift.
E142629
If equipped with steering wheel
paddles, pull the + paddle on the
steering wheel to activate SelectShift.
• Pull the right paddle (+) to upshift.
• Pull the left paddle (–) to downshift.
E144821
The instrument cluster displays your
currently selected gear. If a gear is
requested but not available due to vehicle
conditions (low speed, too high engine
speed for requested gear selection), the
current gear will flash three times.
Focus (CF3) Australia/New Zealand, Vehicles Built From: 15-06-2015, F1EB-19G219-ZAA / F1EB-19G219-ZDA enAUS, Edition date: 05/2015, First Printing
Transmission
Emergency Park Position Release
Lever
Do not drive your vehicle until you
verify that the brake lamps are
working.
This procedure requires you to shift
the gearshift lever out of park (P)
causing your vehicle to roll. Make
sure you fully set the parking brake before
attempting to release the gearshift lever.
If you release the parking brake and
the brake warning lamp remains
illuminated, the brakes may not be
working correctly. The system has
detected a fault that requires service.
Note: For some markets this feature will be
disabled.
Your vehicle is equipped with a brake-shift
interlock feature that prevents moving the
gearshift lever from park (P) when the
ignition is in the on position and the brake
pedal is not pressed.
If you cannot move the gearshift lever out
of park (P) position with the ignition in the
on position and the brake pedal pressed,
a malfunction may have occurred. It is
possible that a fuse has blown or your
vehicle's brake lamps are not operating
properly. See Fuse Specification Chart
(page 174).
If the fuse is not blown and the brake
lamps are working properly, the following
procedure will allow you to move the
gearshift lever from park (P):
120
WARNINGS