Festool PLANEX LHS 225 EQ Original Operating Manual page 16

- If potentially explosive or self-igniting dust is
produced during sanding, the processing in-
structions of the material manufacturer must
be observed under all circumstances.
- Harmful/toxic dusts can be produced during your
work (e.g. lead-containing paint, some types
of wood and metal). Contact with these dusts,
especially inhaling them, can represent a hazard
for operating personnel or persons in the vicinity.
Comply with the safety regulations that apply in
your country. Connect the electric power tool to a
suitable extraction system. To protect your health,
wear a P2 protective mask.
- Never use machines with a damaged cable. Do
not touch damaged cables and pull the plug
from the mains power supply if the cable be-
comes damaged during work. Damaged cables
increase the risk of electric shock.
- Use a maximum of two extension pipes on the
machine.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
5.3 Emission levels
Levels determined in accordance with EN 60745
are typically:
Sound pressure level
Noise level
Measuring uncertainty allowance
CAUTION
The noise produced during work may damage
your hearing.
•
Wear ear protection!
Overall vibration levels (vector sum for three di-
rections) measured in accordance with EN 60745:
Vibration emission level
(3-axis)
Uncertainty
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary es-
timates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
16
6
Risk of accident if the machine is operated using
unauthorised voltages or frequencies.
- The mains voltage and the frequency of the
power source must correspond with the speci-
fi cations on the machine's name plate.
- In North America, only Festool machines with
voltage specifi cations of 120 V may be used.
The switch [5-2] is an on/off switch (I = ON, 0 =
OFF). Connecting and detaching the mains power
cable [1-5], see Fig. [4].
7
Risk of accident, electric shock
 Always pull the plug out of the socket before
performing any type of work on the machine.
7.1
 Hold the sanding head [1-1] with the sanding
pad facing downwards.
 If closed, release the clamping levers [2-1] and
82 dB(A)
[2-2].
93 dB(A)
 Slide the extension pipe [1-2] into the opening
K = 3 dB
up to the stop as illustrated in [2].
 Close the clamping levers [2-1] and [2-2].
 Slide the contact slide [3-2] into the retainer as
illustrated in [3].
 Press the contact slide down until it latches
into position.
 Insert the handle section [1-3] at the same
time.
 If you wish to use the P L A N E X for sanding
walls in cramped spaces, for example, reduce
the length of the machine by fi tting the sanding
2
a < 2.5 m/s
head [1-1] directly to the handle section [1-3].
h
K = 3 m/s²
 When disassembling the machine, do not forget
to press the button [3-1] to release the contact
slide before opening clamping levers [2-1] and
[2-2].
7.2
The machine features full-wave electronics with
the following properties:
Smooth start-up
The electronically controlled smooth start-up func-
tion ensures that the machine starts up smoothly.
Commissioning
WARNING
Machine settings
WARNING
Fitting the P L A N E X
Electronics