Opening The Door; End Of Cycle; End Of The Programme - Electrolux WTSL 6 E201 User Manual

30 www.electrolux.com
The related indicator flashes.
2. Change the options.
3. Touch button Start/Pause - Départ/
Pause again.
The washing programme continues.
11.11 Cancelling a running
programme
1. Press button On Off to cancel the
programme and to deactivate the
appliance.
2. Press button On Off again to activate
the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme, the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment; if
not, fill the detergent again.

11.12 Opening the door

WARNING!
If the temperature and level
of the water in the drum are
too high and the drum still
rotates you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked.
To open the appliance door:
1. Touch button Start/Pause - Départ/
Pause.
The door lock symbol in the display goes
off.
2. Open the appliance door.
3. Close the appliance door and touch
button Start/Pause - Départ/Pause.
The programme or the delay start
continues
11.13 Draining water out after

end of cycle

The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Touch the Start/Pause - Départ/
Pause button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator goes off,
you can open the door.
4. Press On Off some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
11.14 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pause
- Départ/Pause button.
Press the button On Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button On Off to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.

11.15 End of the programme

When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).