Picture Tube Removal - Siemens MCM-19T1 Service Manual

2-4. PICTURE TUBE REMOVAL

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,
after removing the anode.
REMOVAL PROCEDURES
a
1. Turn up one side of the rubber cap in
the direction indicated by arrow a .
HOW TO HANDLE AN ANODE-CAP
1. Do not use sharp objects which may cause damage to the surface
of the anode-cap.
2. Do not squeeze the rubber covering too hard to avoid damaging
the anode-cap. A material fitting called a shatter-hook terminal is
built into the rubber.
3. Do not force turn the foot of the rubber cover. This may cause the
shatter-hook terminal to protrude and damage the rubber.
Demagnetization coil
8
7 Tension spring
A board
6
Neck assy
5
Deflection yoke
4
Four screws
3
(Tapping screw 5)
Picture tube shield
2
Anode cap
1
REMOVAL OF THE ANODE-CAP
b
2. Use your thumb to pull the rubber cap
firmly in the direction indicated by
arrow b .
— 11 —
Two screws
9
(BVTP 4 x 16)
10
Stand assy
(D board)
Cushion
Anode Button
3. When one side of the rubber cap sepa-
rates from the anode button, the an-
ode-cap can be removed by turning the
rubber cap and pulling it in the direction
of arrow c .
MCM-19T1
c