Table of Contents
Advertisement
CLT-2412E-NEW
7/5/02
6:21 PM
NAMES AND CONTROLS
Handset
VOLUME keys
CID ▲ or ▼ key
TALK/CALL BACK key
(also used to END a call)
RINGER switch
REDIAL/DEL
(delete) key
TONE key
CHAN (channel) key
MUTE key
Charging
contacts
Page 8
Earpiece
Incoming call visual
alert LED
LCD screen
7-10-11/HOLD key
CANCEL key
INT (intercom) key
3
1
2
PAUSE key
FLASH/PROG
(program) key
MEM (Memory) key
Microphone
8
INITIAL PROGRAMMING
Before using this telephone, the following initial settings must be
completed:
Language setting
1.
Make sure the phone is OFF (not in TALK mode).
2.
Press FLASH/PROG until
1 1 E E N N G G L L I I S S H H 2 2 F F R R A A 3 3 E E S S P P
screen.
1 1 E E N N G G L L I I S S H H
is factory preset.
Press CID ▲ or ▼ , or the number keys to select the desired
3.
language.
4.
Press FLASH/PROG to confirm.
Area code setting
For proper Caller ID operation, you must program your area code.
1.
Make sure the phone is OFF (not in TALK mode).
2.
Press FLASH/PROG until S S E E T T A A R R E E A A C C O O D D E E - - - - - - shows on
screen.
3.
Enter your 3-digit area code using the number keys.
4.
Press FLASH/PROG to confirm.
Ringer tone setting
1.
Make sure the phone is OFF (not in TALK mode).
2.
Press FLASH/PROG two times until
shows on the screen. 1 is factory-preset.
Press CID ▲ or ▼ , or press the 1 , 2 , or 3 number keys to select the
3.
desired ringer tone.
4.
Press FLASH/PROG to confirm.
Tone/pulse setting
1.
Make sure the phone is off (not in TALK mode).
2.
Press FLASH/PROG until S S E E T T T T O O N N E E / / P P U U L L S S E E shows on screen.
1 1 T T O O N N E E is factory set.
To change to Tone dialing (2 PULSE), press CID ▲ or ▼ , or
3.
press 2.
4.
Press FLASH/PROG to store selection. You will hear a confir-
mation tone.
Resetting to default
You can reset the phone programming to the initial factory default
settings.
9
shows on
S S E E T T R R I I N N G G E E R R T T O O N N E E 1 1 2 2 3 3
Advertisement
Table of Contents
