Proper Usage; Operation - Stanley SPS-750 Original Instructions Manual

G
B
Naked flames in the work area, around
the product and in the vicinity of
flammable materials are prohibited!
Do not smoke in the work area, around
the product and in the vicinity of
flammable materials!
Correct direction of cutting-teeth.
Location of starter handle: pull upwards
Refill chain oil
Do not touch the cutting device until it
stops completely.
114
Guaranteed sound power level
Refill chain oil
During cold start, set the choke lever to
, close the choke.
In a warm start, set the choke lever to
, open the choke.
WARNING! This product produces an
electromagnetic field during operation! This
field may under some circumstances interfere with
active or passive medical implants!
To reduce the risk of serious or fatal injury, we
recommend persons with medical implants to
consult their doctor and the medical implant
manufacturer before operating this product!

Proper usage

This machine is designed exclusively for sawing
wood, for example tree trunks, branches, planks,
etc.
If it is used for any other purpose or if modifications
are made to it, the manufacturer cannot accept any
liability.
Also refer to the safety instructions, the assembly
and operating instructions and also the general
accident prevention regulations.

Operation

1. This product should not be used for any other
purpose than described. Note that national
regulations can restrict the use of this product.
2. Working with this product is demanding;
therefore ensure you are physically and mentally fit
to complete the job safely. Do not use the product
when you are tired, ill or under the influence
of alcohol or other drugs.
3. Pay attention to your posture; always use the
provided harness and keep your back straight
at all times. Do not overwork yourself. Take regular
breaks to ensure concentrated work and full
control over the product.
4. Keep a firm footing and balance during operation.
Always be sure of a safe and secure
operating position, whilst using the product. Never
use the product standing on steps or a ladder.
5. Always wear substantial footwear and long
trousers while operating. Do not operate the
product when barefoot or wearing open sandals.
Wear protective glasses or goggles.
6. Thoroughly inspect the area where the product
is to be used and remove all objects which can be
thrown by the product.
7. Before using the product and after dropping or
other impacts, check for signs of wear or damage
and repair as necessary.
8. Never operate the product with damaged guards
or without the guards in place.
9. Keep hands and feet away from the cutting
means at all times and especially when
switching on the motor.
12