Care And Maintenance; Mixing; Chisel Positioning; Switch Sustained Operation On And Off - Hilti TE 60-AVR Manual

5.2.3 Mixing

Note
Use the mixing paddle only with the quick-release chuck.
Use the mixing paddle only when the reduced power (50 %) setting is active.
1. Insert the quick-release chuck in the power tool's chuck.
2. Fit the mixing paddle into the quick-release chuck.
3. Set the function selector switch to this symbol:
4. Press the power reduction (50 %) button.
◁ The product is ready for use.

5.3 Chisel positioning

9
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function
selector switch until it engages in the "Chiseling" position.
Note
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
1. Set the function selector switch to this symbol:
2. Rotate the chisel to the desired position.
3. Set the function selector switch to this symbol:
◁ The product is ready for use.
5.3.1 Chiseling 10
▶ Set the function selector switch to this symbol:

5.3.2 Switch sustained operation on and off

Note
When chiseling, the control switch can be locked in the "on" position.
1. Push the lockbutton for continuous operation forward.
2. Press the control switch fully.
◁ The product then runs in sustained operating mode.
3. Push the lockbutton for continuous operation back.
◁ The product switches off.

6 Care and maintenance

WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
8 English
Printed: 28.06.2017 | Doc-Nr: PUB / 5277961 / 000 / 01
.
.
until it engages.
.
11