Table of Contents
Advertisement
NOTE:
The same procedures apply in setting the user password and HDD password.
When the supervisor password is set, the Set User Password and Password on Boot
parameters are enabled for users to configure.
Changing a Password
Perform the following to change a password:
NOTE:
Below are the procedures for changing the supervisor password. The same procedures apply
in changing the user and HDD passwords.
Use the
1.
Enter. The Set Supervisor Password dialog box appears.
Type the current password in the Enter Current Password field and press Enter.
2.
Type the new password in the Enter New Password field and press Enter.
3.
Retype the new password in the Confirm New Password field.
4.
Press Enter. If the passwords match, the Setup Notice dialog box appears.
5.
Press Enter to complete the password setting. The computer sets the Supervisor
6.
Password Is parameter to Set.
Press F10 to save changes and exit BIOS Setup Utility.
7.
System Utilities
Downloaded from
www.Manualslib.com
↑
↓
and
keys to highlight the Set Supervisor Password parameter and press
Enter Current Password
Enter New Password
Confirm New Password
Figure 2:6. Set Supervisor Password
Figure 2:7. Setup Notice
manuals search engine
Set Supervisor Password
[
]
[
]
[
]
Setup Notice
Changes have been saved.
[Continue]
2-8
Advertisement
Table of Contents
