Table of Contents
Advertisement
www.freeservicemanuals.info
MECHANICAL ALIGNMENT PROCEDURES
Explanation of alignment for the tape to correctly run
starts on the next page. Refer to the information below
on this page if a tape gets stuck, for example, in the
mechanism due to some electrical trouble of the unit.
Service Information
A. Method for Manual Tape Loading/Unloading
To load a cassette tape manually:
1. Disconnect the AC plug.
2. Remove the Top Cover and Front Assembly.
3. Insert a cassette tape. Though the tape will not be
automatically loaded, make sure that the cassette
tape is all the way in at the inlet of the Cassette
Holder. To confirm this, lightly push the cassette
tape further in and see if the tape comes back out,
by a spring motion, just as much as you have
pushed in.
4. Turn the LDG Belt (B) in the appropriate direction
shown in Fig. M1 until the First Gear starts turn-
ing. Stop turning the LDG Belt (B). Then, turn the
First Gear in the appropriate direction continu-
ously. However, movement of the Cam Gear will
be very slow. Allow a minute or two to complete
this task.
To unload a cassette tape manually:
1. Disconnect the AC plug.
2. Remove the Top Cover and Front Assembly.
3. Make sure that the Moving guide assemblies are in
the Eject Position. When the Moving guide as-
semblies are in the Loading Position, go to step 4.
When the Moving guide assemblies are in the
Eject Position, go to step 6.
4. First, turn the LDG Belt (B) in the appropriate direc-
tion shown in Fig. M1 until the First Gear starts
turning.
5. Stop turning the LDG Belt (B) immediately after the
First Gear starts turning.
6. Turn the First Gear in the appropriate direction until
Moving guide assemblies come to the Eject Posi-
tion. Stop turning when the assemblies begin
clicking or can not be moved further. However,
the tape will be left wound around the cylinder.
7. Turn the LDG Belt (B) in the appropriate direction
continuously, and the cassette tape will be
ejected. As stated, movement of the Cam Gear
will be very slow. Allow a minute or two to com-
plete this task.
06/28/2012
B. Method to place the Cassette Holder in the tape-
loaded position without a cassette tape
1. Disconnect the AC Plug.
2. Remove the Top Cover and Front Assembly.
3. Turn the LDG Belt (B) in the appropriate direction
shown in Fig. M1. Release the locking tabs
shown in Fig. M1 and continue turning the LDG
Belt (B) until the Cassette Holder comes to the
tape-loaded position. Allow a minute or two to
complete this task.
Top View
Moving guide assembly T
(Eject Position)
Moving guide assembly S
(Eject Position)
UNLOAD
/EJECT
First Gear
Bottom View
LDG Belt (B)
Cam Gear
2-3-1
World of Free Manuals
LOAD
UNLOAD
/EJECT
Side View
LDG Belt (B)
Push the tape
to load it.
Push the locking tab gently to unlock
when loading without a cassette.
UNLOAD
/EJECT
First Gear
Fig. M1
Fig. M2
H67T0MA
Advertisement
Chapters
Table of Contents
