<Service Mode>
The service mode is not displayed in the normal state. It is displayed by
entering a pass code.
All hidden menus are displayed when you enter the pass code below.
The uppermost item of the displayed menus is a service mode menu.
Pass code: Enter in the standby state (when the red LED lights) as follows:
Screen display → 5 → Vol+ → Power ON
== Service Mode Menu ==
1) EEP ROM Initialize
2) Chroma Decoder
3) AD Converter
4) White Balance
5) General
6) Manual Control
7) Preset Edit
8) Service Status
SECTION 2
ADJUSTMENTS
2-1. White Balance Adjustment
1. Set the service mode then select White Balance menu.
2. Select Large in the Window menu to output an internal adjustment signal.
3. Set the color temperature to "High".
4. Adjust the white balance so that the color temperature is set to the value
below during R, G, and B gain adjustments.
Color Temperature: 10000K (x=0.281 y=0.288 ±0.005)
5. Set the color temperature to "Middle".
6. Adjust the white balance so that the color temperature is set to the value
below during R, G, and B gain adjustments.
Color Temperature: 8000K (x=0.295 y=0.305 ±0.005)
7. Set the color temperature to "Low".
8. Adjust the white balance so that the color temperature is set to the value
below during R, G, and B gain adjustments.
Color Temperature: 6500K (x=0.314 y=0.324 ±0.005)
KZ-32TS1U(U/C)
2-1