Serene LTRS7946 Installation And Operating Instructions Manual page 9

To install the Towel Rail with concealed supply cord:
7. Establish a suitable position on the wall for attaching the
Towel Rail, with at least two leg Mounting Brackets aligned
with wall studs or dwangs. Mark the wall with the location of
the Concealed Cable Mounting Bracket.
8. The recess in the back of the Cable Mounting Bracket fits
over the flange of the Mounting Base Extension so you will
need to drill a Ø16mm hole in the wall to accommodate the
Extension. If the hole coincides with a wall stud it will be
necessary to drill a hole out of the side of the stud to allow
the Supply Cord to exit.
9. Push the Mounting Base Extension into the Ø16mm hole
firmly until the back of the flange is flush with the wall.
10. Feed the Supply Cord into the wall through the Mounting
Base Extension.
11. Continue with installation as per 'Visible Supply Cord', steps
3 to 9, on page 7.
12. It may be necessary to adjust the Cable Mounting Bracket
so that it fits flush against the wall. This can be done by
loosening the side Leg Fixing Screw and moving the
Bracket forwards or backwards (see Figure 5 below).
13. The wiring must then be connected to a suitable connection
unit. A suitable disconnection device (acting in all supplies)
MUST be incorporated in the fixed supply wiring.
Figure 5: Cable Mounting Bracket Adjustment
LTRS Series
Serene Heated Ladder Towel Rail - Square Profile
Mounting Leg
Leg Fixing Screw
Cable Mounting
Bracket
9