Installation; Regulations; Methods - Serene LTRS7946 Installation And Operating Instructions Manual

2 Installation

Regulations

This appliance MUST be installed in accordance with the
relevant wiring rules and regulations which cover installation of
appliances and accessories in damp situations such as
bathrooms, showers, laundries and other areas with fixed water
containers (In Australia and New Zealand - AS/NZS 3000: 2000
Wiring Rules).
NOTE: This Class II appliance does NOT require Earthing. The
side frames of the Towel Rail should be mounted vertically, with
the heated rails horizontal, and the supply entry at the bottom.
The Heated Ladder Towel Rail is supplied with a 900mm supply
cord and plug. Where protected by an RCD, the Heated Towel
Rail can be plugged directly into a socket outlet, otherwise
permanent connection to the supply via a permanent connection
unit is required. On directly wired models, a suitable
disconnection device (acting in all supplies) must be
incorporated in the fixed supply wiring.
In order to avoid a hazard for young children, this appliance must
be installed so that the lowest heated rail is at least 600mm
above the floor.

Methods

The Towel Rail can be installed with either the supply cord
VISIBLE or CONCEALED inside the bottom mounting leg and
wired directly into the wall.
• To install the Towel Rail with the supply cord VISIBLE,
go to page 6.
• To install the Towel Rail with the supply cord CONCEALED,
go to page 8.
Optional Spacers (see page 10) are available to space the top
Mounting Brackets when the bottom part of the wall is tiled.
4
Serene Heated Ladder Towel Rail - Square Profile
LTRS Series