Table of Contents
Advertisement
4-10. ADJUSTING PHASE OF SWING GEAR AND GEAR (U/D)
3 Let the swing gear through under the
chassis
h
and engage its dowel
with the groove
2 Install the rotary encoder so that
its groove
comes to the position
f
shown in the figure.
1 Insert the shaft gear up to the
position where its shaft comes
out by 5 mm.
7 Gear (U/D)
12
5 Stopper washer (FR)
g
of rotary encoder.
f
8 Screw
(PTPWH M2.6)
4 Push fully the shaft of shaft gear and
align the hole shape of gear (loading B).
6 Screw
g
f
h
Circle mark
Swing gear
(PTPWH M2.6)
Circle mark
Gear (U/D)
Gear (RV)
Fig. A
q; Screw
(PTPWH M2.6)
9 Gear (RV)
Note: Align swing gear, a circle mark
on the gear (U/D), and the teeth
of gear (RV) to the position
showing in the Fig. A.
Advertisement
Table of Contents
