Ceiling Mounting - Honeywell HD262H User Manual

12
For the camera that supports IR, you are required to pay
attention to the following precautions to prevent IR reflection:
•
Dust or grease on the dome cover will cause IR reflection.
Please do not remove the dome cover film until the
installation is finished. If there is dust or grease on the
dome cover, clean the dome cover with clean soft cloth and
isopropyl alcohol.
•
Make sure that there is no reflective surface too close to
the camera lens. The IR light from the camera may reflect
back into the lens and obscure the image.
•
The foam ring around the lens must be seated flush against
the inner surface of the bubble to isolate the lens from the
IR LEDs. Fasten the dome cover to the camera body so
that the foam ring and the dome cover are seamlessly
connected.

Ceiling Mounting

Steps:
1. Attach the mounting template (supplied) to the place where
you want to install the camera.
2. Drill 4 screws holes according to the number 2 screw holes
on the drill template as shown in Figure 1-2.
HD262H(X) Minidome Camera User Guide
800-18622 – A – 07/2014