Optional) Configuring A Working Mode For An Aps Group - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
The working and protection interfaces must be added to the same APS group.
Step 4 Run:
aps protect
The interface added to the APS group is specified as a protection interface.
Step 5 (Optional) Run:
aps signal-low-priority
The low-priority signal failure code for a switching request carried in the K byte is specified on
the protect interface.
An APS protect interface uses the K type in an APS packet to negotiate with the APS protect
interface on the remote end. By default, the high-priority signal failure code for a switching
request is used. If the low-priority code is used on the APS protect interface on the remote end,
the high-priority code on the APS protect interface on the local end must be changed to the low-
priority code.
----End

3.2.4 (Optional) Configuring a Working Mode for an APS Group

The APS auto protection switchover mode can be configured only on a protect interface in an
APS group.
Context
Do as follows on a protect interface in an APS group:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface
or
controller cpos
The interface view is displayed.
Step 3 Run:
aps mode
bidirection }
A working mode is configured for the APS group. The configuration of APS mode takes effect
after the shutdown and undo shutdown commands are used on the protect interface
l one2one bidirection:
Issue 02 (2011-09-10)
CAUTION
interface-type interface-number
cpos-number
{ one2one bidirection | one-plus-one unidirection | one-plus-one
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 APS Configuration
37